Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
EFIE Build Question
Author Message
hydrodine Offline
Member
***

Posts: 206
Joined: Mar 2008
Reputation: 0
Post: #1
EFIE Build Question
Hi Mike,
I have a build question on the efi, C2 states 8.8 nf. I can not find one anywhere. What value are you using?

Thanks,
Barry
03-22-2008 11:52 AM
Find all posts by this user Quote this message in a reply
mike Offline
Senior Member
****

Posts: 2,020
Joined: Jul 2007
Reputation: 7
Post: #2
RE: EFIE Build Question
I use 10 nF there. I've used 6.8 nF in the past. Check out the 555 documentation. Go down to the diagram for astable operation. Look close for Note A. You'll see that the part may not even be required. It's not used for timing or anything so I've never considered it's exact value to be important.

[Image: signature.gif]
Visit Our Documents Page
03-22-2008 12:32 PM
Visit this user's website Find all posts by this user Quote this message in a reply
hydrodine Offline
Member
***

Posts: 206
Joined: Mar 2008
Reputation: 0
Post: #3
RE: EFIE Build Question
Just getting around to building a single efi. My question is replacing the switch with the relay, how does it wire in?

Thanks,
Barry
04-22-2008 09:39 AM
Find all posts by this user Quote this message in a reply
mike Offline
Senior Member
****

Posts: 2,020
Joined: Jul 2007
Reputation: 7
Post: #4
RE: EFIE Build Question
I sent you a PM with the diagram.

[Image: signature.gif]
Visit Our Documents Page
04-22-2008 10:04 AM
Visit this user's website Find all posts by this user Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)