Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
EFIE confusion
Author Message
nucleoside Offline
Member
***

Posts: 4
Joined: Feb 2008
Reputation: 0
Post: #1
EFIE confusion
Hey, I just installed a double EFIE on my audi V6 along with a water electrolyzer. I've been attempting to tune the EFIE, but the numbers from my digital multimeter are very different than what you have described in your instructions.

When I plug the leads into the red and black matching the EFIE I get a negative polarity reading. Secondly after I switch the leads colors Im getting readings of positive polarity (even though the leads are opposite) + 1.5 volts. I think this would translate to 1,500 mV? Am I correct in my conversion of units. I followed my wiring harness to hook up the efie and Im fairly certain that I wired it in correctly. I determined the set of wires for the heating element for the O2 sensor and differentiated that from the computer signal. Did I completely miss it?

HELP!
(This post was last modified: 02-25-2008 10:37 PM by nucleoside.)
02-25-2008 10:35 PM
Find all posts by this user Quote this message in a reply
Post Reply 


Messages In This Thread
EFIE confusion - nucleoside - 02-25-2008 10:35 PM
RE: EFIE confusion - mike - 02-25-2008, 11:20 PM
RE: EFIE confusion - nucleoside - 02-26-2008, 09:51 AM
RE: EFIE confusion - nucleoside - 02-26-2008, 02:03 PM
RE: EFIE confusion - mike - 02-26-2008, 04:14 PM
RE: EFIE confusion - nucleoside - 02-26-2008, 09:03 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)