Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
EFIE setup help needed
Author Message
a3holerman Offline
Member
***

Posts: 31
Joined: May 2008
Reputation: 0
Post: #1
EFIE setup help needed
Hi,
New to this arena and am having a great time experimenting. Have just about finished a Smacks cell and already see several ways to improve it.

My question is this about the setting of the EFIEt I bought here. Would it not be possible to warm the engine up and measure the output from the O2 sensor then add the HHO gen and measure the output again and adjust the EFIE give the same output. I realize the output jumps around but in aditional to a Fluke digital vom I also have a scope that I could use.

Without other exotic measuring equipment would this not enshure having the same F/A ratio?

If one changes HHO generators, one with more output for instance, would you not have to readjust the EFIE

Ant thoughts will greatly be appreciated..


Tom
Cape Cod
(This post was last modified: 06-18-2008 03:26 PM by a3holerman.)
06-18-2008 12:17 PM
Find all posts by this user Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)