Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
EFIE support need help
Author Message
Randy Offline
Member
***

Posts: 1
Joined: May 2008
Reputation: 0
Post: #1
Question EFIE support need help
I just installed Your new dual O2 EFIE On my isuzu Rodeo 1998 3.2 v6. fuel injected with hho gen
I have 4 o2 sensor 2 upstream & 2 downstream with 4 wires .My reading are .055 millivolts with no hho and .096 with hho. the reading seem to low . Is this correct . do I add .040 millivolts . because I can't adj. one side of the EFIE Below .310mv
(This post was last modified: 05-05-2008 03:48 PM by Randy.)
05-05-2008 05:42 AM
Find all posts by this user Quote this message in a reply
mike Offline
Senior Member
****

Posts: 2,020
Joined: Jul 2007
Reputation: 7
Post: #2
RE: EFIE support need help
Randy, please disconnect the white, green, blue and brown wires, and see if you get the expected voltages at the test ports.

I suspect either you're hooked up the wrong wires, or you don't have oxygen sensors, but AFR (Air Fuel Ratio) sensors. See http://www.fuelsaver-mpg.com/doc/HowManyEFIEs.html for more info on that.

Send me an email at support@fuelsaver-mpg.com with the info, as I'm getting behind on my forum traffic. Don't assume I'll remember anything. Copy your first post, and then give me the additional data I'm asking for in the email.

[Image: signature.gif]
Visit Our Documents Page
05-06-2008 09:06 AM
Visit this user's website Find all posts by this user Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)