(02-04-2009 08:04 AM)jrobillard Wrote:  Thanks for the info. Im installing the cell on a 4.0L V-6. My problem is that the unit is drawing alot of current, about 30 amps. Im wondering if this is normal.

If I'm right that cell is +-+-+-+-+-+ It needs a few neturals in there to lower the amps and tempture, it will run hot like that. If you really want to stick with that cell try running +nnnn-nnnn+ that should bring the temp and anps down. Then you can adjust the amps by adding or removing (robic) from the water. But still the best you'll get is about 1/3 liter of hho. It just doesn't have enought steel.You get about 1.25 millilerters of gas per min for every sq. inch of steel you have,my math could be a little off. Good luck

(10-28-2008 04:33 PM)ted Wrote:  good advice just report back to click with the words THIS IS A SCAM> I had my funds returned on the credit card in twentyfour hours.

I sure would like my money back but can't figure out how to go about it. Gas4free is a scam as far as i'am concerned. I had to try and figure everything for myself and still no good production. The tech support is non existant. Save your money and don't buy from these guys.

(10-16-2008 05:39 PM)ted Wrote:  I also have a 350 engine in a 1989 gmc suburban hard to say what you need start small work it up. your 2min liter is where I was a few weeks back . Iam now working with a 2 liter production in 2 minutes. almost double where you are.
I have two seperate generator cells in one container wired in series,mix is 4 tsp BS ,1500ml water.I ran non-stop 3 hours,just warm contacts warm to touch.poured out mixture it was like bath water in temperature.production began picking up in the 3rd hour to 1liter in 50 sec. Amp draw was 8.5 I will post my plate design if anyone should ask . my next step up which will be 6 gens in series and 3 liters per minute.if my math is correct its just a matter of assembly time and she will be ready. It will work the same as the unit I just tested .I hope things have a way of turning around so I can only hope for the best.

---

Ted,

Please send me the plates arraangment you mentioned. I will start to do my max cell...Thanks!!

DESPERATE FOR HELP ! Does anyone have the CORRECT plate design and mixture, etc., that is working. Every time I attempt to utilize the device I made, it blows the fuse. Every single time. I would appreciate any and all replies to correct my problem. For sure by now I feel SCAMMED by this Gas4 Free website. Please advise me of what to do.

Thank you,
Bill

Have you checked that there is not a short in the unit. Drain all the liquid out and hook a meter to the poles and see if you have a complect circut, if you do there is the problem. If you using the deal in a glass jar and wire wraped around the plastic x throw it away and start over with a dry cell. I found my 21 plate on e-bay for a little over $100.00.