Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Gettin ready to build a 6x6 cell
Author Message
Donor Offline
Member
***

Posts: 24
Joined: Jan 2012
Reputation: 0
Post: #1
Question Gettin ready to build a 6x6 cell
Hey all getting my stuff togather here for my 6x6 21 plate. I am using 316L s.s. with the showerpan liner. My ? is It seems easier to put all the bolts around the outside of the cell versus through, any opernions on that and if i run them through do you just use tubing on the shaft of the bolt ? Seems less chance of it leaking completely if all bolts go outside of the cell. Also what size hole through the plates at the top ?
01-22-2012 10:51 AM
Find all posts by this user Quote this message in a reply
Donor Offline
Member
***

Posts: 24
Joined: Jan 2012
Reputation: 0
Post: #2
RE: Gettin ready to build a 6x6 cell
Doesn't seem like people respond very often.
01-24-2012 07:40 PM
Find all posts by this user Quote this message in a reply
_Expedition_ Offline
Member
***

Posts: 1
Joined: Jul 2012
Reputation: 0
Post: #3
RE: Gettin ready to build a 6x6 cell
If you put holes in your plates to bolt them together just put shrink tubing over the bolts and use a heat gun or blow dryer to shrink the tubing down on the bolts. That's what I did. Worked perfect. I liked putting the holes through the plates so I know my plates aren't going anywhere....jus sayin. I've seen it done both ways and seems to work both ways. Just make sure u use the shrink tubing. It's good stuff.
07-10-2012 05:07 PM
Find all posts by this user Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)