Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Instalation - which side is which in the double?
Author Message
keenman11 Offline
Member
***

Posts: 46
Joined: Jan 2008
Reputation: 0
Post: #1
Instalation - which side is which in the double?
Mike,
I did receive my double EFIE today as promised. I am going to mount my EFIE under my dash, to the right of the steering column using the holes provided in the EFIE. The on/off switch will be on the left. I am only going to use the left side for this car. Which two wires do I use for the O2 sensor & the computer? Green & White or Brown & Blue?
02-06-2008 06:58 PM
Find all posts by this user Quote this message in a reply
mike Offline
Senior Member
****

Posts: 2,020
Joined: Jul 2007
Reputation: 7
Post: #2
RE: Instalation - which side is which in the double?
The green/white wires are controlled by the set screw closest to the switch. The blue/brown wires are controlled by the set screw furthest from the switch. The test ports nearest each set screw are the ones to use that set screw. So it's up to you, which ones you use.

I always think of the white/green wires as EFIE #1 and the blue/brown wires as EFIE #2. That's because I use white/green on a single EFIE. But it doesn't matter. The circuits are entirely independent of each other, so use whichever is most convenient for you.

[Image: signature.gif]
Visit Our Documents Page
02-07-2008 02:26 AM
Visit this user's website Find all posts by this user Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)