Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
My results blew up
Author Message
CaptCoolHand Offline
Member
***

Posts: 2
Joined: May 2008
Reputation: 0
Post: #1
My results blew up
I was testing out the gen today on my work bench, and it blew up when I hooked it up for the second run. I'm guessing that I failed to air out the cell after the first test, then there was a short inside. I will not be using any copper inside the gen from now on, and all subsiquent tests will be properly aired out.

SAFETY FIRST!!!!!!

scared the poop outa me

good luck and be careful
05-27-2008 05:15 PM
Find all posts by this user Quote this message in a reply
colchiro Offline
Moderator
*****

Posts: 3,265
Joined: Feb 2008
Reputation: 11
Post: #2
RE: My results blew up
We want pics. Wink

Be careful or you'll have to change your name to CaptHook. Hmm

Rick

Links: Documents / Tuning for Mileage | Toyota Sensors | Autoshop Sensor Tutorials
05-27-2008 07:13 PM
Find all posts by this user Quote this message in a reply
wulfram Offline
Hauptmann Hydro
****

Posts: 303
Joined: Apr 2008
Reputation: 4
Post: #3
RE: My results blew up
lol. Similar thing happened to me today. Left the generator on (with the hood up) for 1 minute while I ran inside to get some silicon caulking and as I was about to turn the corner.. BOOM! The pressure built up and blew the top off the lid (blew the lid to pieces in the process). Fortunately, the glass jar was fine and nothing else but the lid and my hearing was damaged.
Lots of HHO gas produced in one minute with my setup. Smile
05-27-2008 07:32 PM
Find all posts by this user Quote this message in a reply
CaptCoolHand Offline
Member
***

Posts: 2
Joined: May 2008
Reputation: 0
Post: #4
RE: My results blew up
colchiro Wrote:We want pics. Wink

Be careful or you'll have to change your name to CaptHook. Hmm


I'll try and get some pics. Nothing very interesting now, but a broken tupperware and some rust spots. Made one hellofa BOOM!
05-28-2008 05:39 AM
Find all posts by this user Quote this message in a reply
Fatman1 Offline
Member
***

Posts: 78
Joined: May 2008
Reputation: 0
Post: #5
RE: My results blew up
Sound like you have a good one going. Has anyone tryed Plumbing Goop for coating things, it cost more than silicon but it flows in to tight places( as in crimbed ends ) been useing alot time and love the stuff, so far not seen it act in a bad way on anything .Just my 2 centsSmile
05-28-2008 07:52 PM
Find all posts by this user Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)