Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Newbie here
Author Message
T-Bone Offline
Member
***

Posts: 11
Joined: May 2008
Reputation: 0
Post: #1
Newbie here
I have in recent weeks with a few friends researched the subject of HHO generator construction and installation. I have a couple of questions. Is it always necessary to install a MAP sensor enhancer and EFIE to recognize the best fuel efficiency? If I Install a MAP sensor enhancer only will my O2 sensors tell my computer the MAP sensor is lying and compensate? If so Has anyone seen or heard of the Zero-Signal method of eliminating O2 sensors?
Test Vehicle Is A 2000 Chevy Pickup 5.3 Vortec engine.
Thanks for your input
T-Bone
05-28-2008 08:21 PM
Find all posts by this user Quote this message in a reply
Fatman1 Offline
Member
***

Posts: 78
Joined: May 2008
Reputation: 0
Post: #2
RE: Newbie here
In my research I have found most to belive it depends on how much HHO u are using.I have a 97 350 vortec and got about 1 lpm going in . All I done was to put a stand off on the O2 sensor. Im have a smack type making little over 1 lpm. I installed the stand off at the same time as the HHO gen.They have some great info in here about it and if U shop around some good buys
05-31-2008 05:10 AM
Find all posts by this user Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)