Scan Tool ?

[pdai11]

I am looking to buy a Scantool not too expensive. Looking at either the Scangauge or the Turbogauge. After reading their spec, i cannot find on any of their descriptions on reading the MAF sensor, both only states the MAP sensor or do i have to spend more on purchasing one that can read the MAF ?

Thanks

[mike]

I can't answer directly. But contact the manufacturers. If I remember correctly, with both tools you can go into a set up function and select the parameters to display.

Not all engines have a MAF, so it may not be specifically mentioned. But likely both tools can show MAF output. It's just another datum in the OBD2 data stream, and is no different than obtaining the MAP output.

[pdai11]

Thanks Mike, i'll contact them.