Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Which method works better, plates or round?
Author Message
RDKamikaze Offline
Because Saving Gas Matters
***

Posts: 752
Joined: Jul 2008
Reputation: 4
Post: #1
Which method works better, plates or round?
Hello! I'm seeing that a popular way to build the anodes for HHO gens. is to make them in a plate formation. However, I have seen a few setups where people just get two long plates or so of ss and roll them together. I have not been able to find any information on these really other than on a website that I found, http://www.diyhydrogenhho.com . I'm currently modeling my anode design off of that one, by using 6"x12" 304 stainless 18ga sheets instead of 4"x12" 16ga.

Does anybody have their setup similar to this? If so, what are your outcomes usually, and which design, plate or round, does everyone think would produce more HHO faster with the same variables (Amps, volts, electrolyte, etc.)?

My Car:
2006 Toyota Solara 2.4L 4cyl.
-Aftermarket (JPP) header
-DNX exhaust
-Injen Short-Ram Intake (SRI)

Add yourself to the HHO member map!!
(This post was last modified: 07-08-2008 07:44 PM by colchiro.)
07-08-2008 07:34 PM
Visit this user's website Find all posts by this user Quote this message in a reply
Post Reply 


Messages In This Thread
Which method works better, plates or round? - RDKamikaze - 07-08-2008 07:34 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)