Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
drycell design looking for feedback
Author Message
reggaerican Offline
Member
***

Posts: 4
Joined: Jun 2012
Reputation: 0
Post: #1
drycell design looking for feedback
hello I am completly new to hho production but have done some research on different drycells and this is what I came up with for my design..
The plan is to make it 7x13 so that the surface area after gasket is 6x12.
I will be staggering the holes at the bottom and using weld-on 16 on all holes.
The plan is to have them media blasted, but I have not found a source for that yet and depending on the price might not even be an option (maybe have to cross sand).
I have seen were lots of people have been placing there power tabs kitty corner (2 pos and 2 neg) since this is a larger cell I want to go with three. Is this good, bad oeverkill more or less efficient????

please comment whatever your thoughts are good or bad Thanks


Attached File(s) Thumbnail(s)
   
06-20-2012 03:08 PM
Find all posts by this user Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)