Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
high altitude
Author Message
yahooty Offline
Member
***

Posts: 5
Joined: Jun 2008
Reputation: 0
Post: #1
high altitude
I was wondering if anyone had tested at high altitude. I plan on driving my truck in the mountains of New Mexico and Colorado.> 8000 ft. My question is what would the effect be at higher altitude? Should I put a switch on the efie so I could turn it off and still run the cell at altitude or just let the ECM figure it out? I will also be pulling a 5th wheel. Thanks
07-15-2008 01:56 PM
Find all posts by this user Quote this message in a reply
skiers4ever Offline
Member
***

Posts: 160
Joined: May 2008
Reputation: 0
Post: #2
RE: high altitude
Hi yahooty, I'm at 10,000 feet in the mountains of Colorado. The 21st of this month will be two months that I've been running the Gen. No problem whatsoever with the altitude. I don't have an EFIE or anything...just the Gen hooked up. I would put a switch on your EFIE though just to be on the safe side. I'm building a MAP adjuster with an on/off switch just in case but don't have it done yet. I doubt you'll have any problems but a cheap on/off switch is worth the insurance. Have fun in Colorado and New Mexico! John

2007 Honda Ridgeline 3.5L 4WD
Hydro Super 2 installed on 5/21/08
Colorado - 10,000 Feet!
07-15-2008 02:29 PM
Find all posts by this user Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)