Fuel-Saver Forums
Cross Hatch Plates (Knurled) - Printable Version

+- Fuel-Saver Forums (http://www.fuel-saver.org)
+-- Forum: Fuel Efficiency Technologies (/Forum-Fuel-Efficiency-Technologies)
+--- Forum: Hydrogen/Brown's Gas Systems (/Forum-Hydrogen-Brown-s-Gas-Systems)
+--- Thread: Cross Hatch Plates (Knurled) (/Thread-Cross-Hatch-Plates-Knurled)



Cross Hatch Plates (Knurled) - dirty273 - 06-25-2008 07:24 AM

Has anyone ever tried to use an end mill or horizontal mill to hatch the steel plates?So they look like a knurl or something really rough. I just wonder if this would make a difference as to the sanding only?

I dont have access to a mill or I would give a go. Just a thought.

The plates might do better if the surface of each looked like sharp points reaching to the other.